Yamaha Arius YDP-C71 Panduan Pemilik - Halaman 30
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Papan Ketik Elektronik Yamaha Arius YDP-C71. Yamaha Arius YDP-C71 38 halaman. Owner's manual
Juga untuk Yamaha Arius YDP-C71: Panduan Referensi (6 halaman), Panduan Pengoperasian Cepat (2 halaman), Panduan Pengoperasian (13 halaman)
Halaman Cetak
Appendix
6
Connect the pedal cord.
6-1 Insert the pedal cord plug to the [PEDAL] jack
from the rear.
6-2 Attach the cord holders to the rear panel as
shown, then clip the cord into the holders.
6-3 Use a vinyl tie to take up any slack in the pedal
cord.
6-2
Insert the pedal cord securely until the metal part of the
cord plug disappears from view.
Otherwise, the pedal may not function properly.
7
Connect the power cord to the unit.
7-1 Set the voltage selector (for models that feature a
voltage selector).
30
YDP-C71 Owner's Manual
6-1
6-3
Insert the cord all the
way until the metal
part of the plug
disappears from view.
127
240
Voltage Selector
Before connecting the AC power cord, check the
setting of the voltage selector which is provided in some
areas. To set the selector for 110V, 127V, 220V or 240V
main voltages, use a "minus" screwdriver to rotate the
selector dial so that the correct voltage for your region
appears next to the pointer on the panel. The voltage
selector is set at 240V when the unit is initially shipped.
After the proper voltage has been selected, connect the
AC power cord to the [AC IN] jack and an AC wall
outlet. A plug adaptor may be also provided in some
areas to match the pin configuration of the AC wall
outlets in your area.
7-2 Connect the plug on the power cord to the rear
panel connector.
WARNING
An improper voltage setting can cause serious damage to
this instrument or result in improper operation.
8
Set the adjuster.
Rotate the adjuster until it comes in firm contact
with the floor surface.
9
Attach the headphone hanger.
Use the included two screws 6 (4 10mm) to attach
the hanger as shown in the illustration below.