- ページ 30

電子キーボード Yamaha Arius YDP-C71のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Yamaha Arius YDP-C71 38 ページ。 Owner's manual
Yamaha Arius YDP-C71 にも：リファレンス・マニュアル (6 ページ), クイック・オペレーション・マニュアル (2 ページ), 操作マニュアル (13 ページ)

ページを印刷する

Appendix

Connect the pedal cord.

6-1 Insert the pedal cord plug to the [PEDAL] jack

from the rear.

6-2 Attach the cord holders to the rear panel as

shown, then clip the cord into the holders.

6-3 Use a vinyl tie to take up any slack in the pedal

cord.

6-2

Insert the pedal cord securely until the metal part of the

cord plug disappears from view.

Otherwise, the pedal may not function properly.

Connect the power cord to the unit.

7-1 Set the voltage selector (for models that feature a

voltage selector).

YDP-C71 Owner's Manual

6-1

6-3

Insert the cord all the

way until the metal

part of the plug

disappears from view.

127

240

Voltage Selector

Before connecting the AC power cord, check the

setting of the voltage selector which is provided in some

areas. To set the selector for 110V, 127V, 220V or 240V

main voltages, use a "minus" screwdriver to rotate the

selector dial so that the correct voltage for your region

appears next to the pointer on the panel. The voltage

selector is set at 240V when the unit is initially shipped.

After the proper voltage has been selected, connect the

AC power cord to the [AC IN] jack and an AC wall

outlet. A plug adaptor may be also provided in some

areas to match the pin configuration of the AC wall

outlets in your area.

7-2 Connect the plug on the power cord to the rear

panel connector.

WARNING

An improper voltage setting can cause serious damage to

this instrument or result in improper operation.

Set the adjuster.

Rotate the adjuster until it comes in firm contact

with the floor surface.

Attach the headphone hanger.

Use the included two screws 6 (4 10mm) to attach

the hanger as shown in the illustration below.