Yamaha H01AG Panduan Pemilik - Halaman 23
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Papan Ketik Elektronik Yamaha H01AG. Yamaha H01AG 30 halaman. Quick operation guide
Juga untuk Yamaha H01AG: Panduan Pengoperasian Cepat (2 halaman)
Halaman Cetak
2.
Raise A to the vertical position.
2-1
Raise A to the vertical position, with the keyboard
side on the bottom, and hold A securely.
CAUTION
Do not release A until you
finish Step 4.
A A
CAUTION
Do not tip A further than 90 degrees to avoid stress to the
key cover and lid.
3.
Attach B.
3-1
Align the holes on A with those on B and hold A
and B together.
3-2
Finger-tighten six short screws (6x20 mm) start-
ing with the top hole.
3-3
Tighten the screws securely.
A
A
4.
Attach C.
4-1
Hold C so that the notch on the bracket will face
toward left, then align the holes on A with those
on C.
4-2
Finger-tighten four short screws (6x20 mm) start-
ing with the top hole.
4-3
5.
5-1
5-2
B
B
5-3
Hold E securely to avoid slippage.
Tighten the screws securely.
A
Assemble the pedal structure.
Pass the pedal cord (that comes out from the rear
of pedal box E) through a hole on the bracket of
D, then pass it through the pipe.
D
E
E
Align the holes on the bottom of E with the holes
on the bracket of D, then attach E and D by tight-
ening six small screws (4x6 mm). At this time,
first tighten the two center screws, then tighten
the rest of the screws.
Pull the end of the pedal cord to eliminate any
slack inside the bracket on D.
D D
E
CAUTION
Keyboard Stand Assembly
C C
23
H01 Owner's Manual