Yamaha AG-Stomp Panduan Pemilik - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Yamaha AG-Stomp. Yamaha AG-Stomp 32 halaman. Yamaha accoustic guitar/pre-amplifier owner's manual
Juga untuk Yamaha AG-Stomp: Panduan Servis (45 halaman), Daftar Tambalan (1 halaman), Manual (Belanda) (32 halaman)

Yamaha AG-Stomp Panduan Pemilik
Using the AG-Stomp
The previously described rules apply to all knobs
except the OUTPUT knob.
The MIC TYPE SELECT switch also functions in
the same manner. When the knob is rotated, the
Mic Simulator type that is set in the patch data
will flash in the display. After rotating the knob
to the position of the Mic Simulator type indi-
cated in the display, select the Mic Simulator type
you want to use.
The OUTPUT knob and VOLUME knob
Either knob can be used to change the volume how-
ever, the VOLUME knob setting is stored in the patch
data while the OUTPUT knob's setting is not. Use
the VOLUME knob to set the volume of each patch
and use the OUTPUT knob to control the AG-
stomp's output volume.
G Changing Effect Settings
Try switching each of the Effect Blocks ON/OFF or
try changing the effect. Also, try rotating knobs for
each of the effects to change the character of the
effect.
The AG-Stomp's effects section is divided into the
following three blocks.
• Limiter (LIMITER)
• Chorus/Delay (CHORUS/DELAY)
• Reverb (HALL/ROOM/PLATE)
• Press the button of the effect you want to use to
select it (the lamp will light).
• In the Chorus/Delay and Reverb blocks, only one
effect per block can be used at a time.
Also, pressing a button that is lit will result in the
light going off and the effect in that block being
deactivated.
All knobs can be used to set or edit parameters
of the block's selected effect.
* Refer to the "Effect Functions and Parameters" section on
page 21 for more information on the function and knob set-
tings for individual effects.
* The operation of each of the effect's knobs follows the same
rules as described in the pre-amp section.
14
G Set the Tone Control's Center Fre-
quency
The BASS, MIDDLE, TREBLE and PRESENCE
tone controls each have a variable center frequency.
[Procedure]
1. Press the [SHIFT] button so that its lamp flashes
(enter the SHIFT mode).
2. To adjust the Center Frequency, rotate the Tone
Control of the related frequency range you want
to set. Turn the knob to the left (counter-clock-
wise) to lower the center frequency, or turn the
knob to the right (clockwise) to raise the center
frequency.
Variable Range
• BASS ............... 50Hz - 400Hz
• MIDDLE ........... 200Hz - 1.6kHz
• TREBLE ........... 600Hz - 4.8kHz
• PRESENCE ..... 2.0kHz - 16kHz
3. Press the [SHIFT] button so that its lamp turns
off (exit the SHIFT mode).
* If no editing is performed after 5 seconds of entering the
SHIFT mode, the mode will automatically be exited.
* A list of note names corresponding to each of the acoustic
guitar's frets and their standard frequencies is provided in
the supplemental "Patch List".
Please use the list when setting the Tone Control's Variable
Center Frequency.
Tone Control Center Frequency settings are
stored in Patch Data.