Yamaha AG-Stomp Owner's Manual - Page 14

Browse online or download pdf Owner's Manual for Amplifier Yamaha AG-Stomp. Yamaha AG-Stomp 32 pages. Yamaha accoustic guitar/pre-amplifier owner's manual
Also for Yamaha AG-Stomp: Service Manual (45 pages), Patch List (1 pages), (Dutch) Handleiding (32 pages)

Print Page

Using the AG-Stomp

The previously described rules apply to all knobs

except the OUTPUT knob.

The MIC TYPE SELECT switch also functions in

the same manner. When the knob is rotated, the

Mic Simulator type that is set in the patch data

will flash in the display. After rotating the knob

to the position of the Mic Simulator type indi-

cated in the display, select the Mic Simulator type

you want to use.

The OUTPUT knob and VOLUME knob

Either knob can be used to change the volume how-

ever, the VOLUME knob setting is stored in the patch

data while the OUTPUT knob's setting is not. Use

the VOLUME knob to set the volume of each patch

and use the OUTPUT knob to control the AG-

stomp's output volume.

G Changing Effect Settings

Try switching each of the Effect Blocks ON/OFF or

try changing the effect. Also, try rotating knobs for

each of the effects to change the character of the

effect.

The AG-Stomp's effects section is divided into the

following three blocks.

• Limiter (LIMITER)

• Chorus/Delay (CHORUS/DELAY)

• Reverb (HALL/ROOM/PLATE)

• Press the button of the effect you want to use to

select it (the lamp will light).

• In the Chorus/Delay and Reverb blocks, only one

effect per block can be used at a time.

Also, pressing a button that is lit will result in the

light going off and the effect in that block being

deactivated.

All knobs can be used to set or edit parameters

of the block's selected effect.

* Refer to the "Effect Functions and Parameters" section on

page 21 for more information on the function and knob set-

tings for individual effects.

* The operation of each of the effect's knobs follows the same

rules as described in the pre-amp section.

G Set the Tone Control's Center Fre-

quency

The BASS, MIDDLE, TREBLE and PRESENCE

tone controls each have a variable center frequency.

[Procedure]

1. Press the [SHIFT] button so that its lamp flashes

(enter the SHIFT mode).

2. To adjust the Center Frequency, rotate the Tone

Control of the related frequency range you want

to set. Turn the knob to the left (counter-clock-

wise) to lower the center frequency, or turn the

knob to the right (clockwise) to raise the center

frequency.

Variable Range

• BASS ............... 50Hz - 400Hz

• MIDDLE ........... 200Hz - 1.6kHz

• TREBLE ........... 600Hz - 4.8kHz

• PRESENCE ..... 2.0kHz - 16kHz

3. Press the [SHIFT] button so that its lamp turns

off (exit the SHIFT mode).

* If no editing is performed after 5 seconds of entering the

SHIFT mode, the mode will automatically be exited.

* A list of note names corresponding to each of the acoustic

guitar's frets and their standard frequencies is provided in

the supplemental "Patch List".

Please use the list when setting the Tone Control's Variable

Center Frequency.

Tone Control Center Frequency settings are

stored in Patch Data.