Yamaha DSP-A970 Panduan Pengoperasian - Halaman 46
Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Penguat Yamaha DSP-A970. Yamaha DSP-A970 48 halaman. Digital sound field processing amplifier
Halaman Cetak
PROBLEM
Power does not come on.
Hum.
No sound.
No sound from the effect speakers.
No sound from the front
effect speakers.
No sound from the center speaker.
The sound suddenly goes off.
DSP parameters or other settings on this
unit cannot be changed.
The sound field cannot be recorded.
The remote control unit does not function
properly.
Noise from nearby TV or tuner.
The TRANSMIT/LEARN indicator blinks
twice when learning a function.
Continuous functions such as volume are
learned, but operate only for a moment
before stopping.
44
TROUBLESHOOTING
POSSIBLE CAUSE
AC cord not properly plugged in.
Bad cable connection.
Bad or incorrect input connection.
Incorrect input source selection.
The EFFECT switch is set off.
The DOLBY PRO LOGIC program is being used
with material not encoded with Dolby Surround.
The FRONT MIX switch is set
to "ON".
The center mode is in "PHNTM".
Incorrect sound field program.
The protection circuit has activated because of
short circuit etc.
The "MEMORY GUARD" function is
set ON.
It is not possible to record the sound field on a
tape deck connected to this unit's TAPE
REC OUT jacks.
Dead batteries.
Wrong distance or angle.
Direct sunlight or lighting (of an inverter type of
flourescent lamp etc.) is striking the remote
control sensor of the main unit.
This unit is too close to the affected
equipment.
Memory is full.
Learning process incomplete.
WHAT TO DO
Carefully plug AC plug into outlet.
Firmly plug in all connection cables.
Check connections.
Select the appropriate input source with the input selector switch.
Press the EFFECT switch to turn on.
Use a different sound field program.
Set the FRONT MIX switch to "OFF".
Select the appropriate center mode.
Select the appropriate program.
Turning the unit off and then on will reset the protection circuit.
Turn the "MEMORY GUARD" OFF.
Replace batteries.
The remote control unit will function from a maximum range of 7
meters, no more than 30 degrees off-axis from the front panel.
Change position of the main unit.
Move the unit further away from the affected equipment.
Erase unnecessary functions.
Be sure to press the function key on the other remote control
until the TRANSMIT/LEARN indicator is extinguished.