Caliber 13576 Manual Petunjuk Perakitan - Halaman 3

Jelajahi secara online atau unduh pdf Manual Petunjuk Perakitan untuk Aksesori Mobil Caliber 13576. Caliber 13576 8 halaman. Sled wheels
Juga untuk Caliber 13576: Manual Petunjuk Perakitan (10 halaman)

Halaman Cetak

4. Apply one fourth of the

grease (22) to each axle (2)

and assemble a wheel (1),

½" washer (3), arm (6 and

7), and hex nut (4).

Tighten the axle until snug,

then tighten the axle 1/4 -

1/2 turn more with a T-55

Torx wrench. Repeat for

each of the three remaining

wheels.

5. Slide the assembled arms

onto the splined T-Handle

(10) and adjust the arms

approximately ½" wider

than the ski. It may be

useful to spread the arm

clamp with a flat blade

screwdriver. Some sleds

have spindle bolts that stick

beyond the edge of the ski,

for these sleds adjust the

arms wider to avoid the

bolt (or cut the excess bolt off). The arm angle can be adjusted 15° to accommodate tall or short ski loops. Most

sleds work best at 15°. Use two ¼-20 x 1.0" (13), two ¼" washers (15), and two ¼ square nuts (14) to secure the

arms in place using the supplied 5/32" hex wrench (8). Do not overtighten. Make sure both arms are installed at

the same angle.

- Page 3 -

CI05067, rev B