Caliber 13576 조립 지침 매뉴얼 - 페이지 3

{카테고리_이름} Caliber 13576에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Caliber 13576 8 페이지. Sled wheels
Caliber 13576에 대해서도 마찬가지입니다: 조립 지침 매뉴얼 (10 페이지)

4. Apply one fourth of the

grease (22) to each axle (2)

and assemble a wheel (1),

½" washer (3), arm (6 and

7), and hex nut (4).

Tighten the axle until snug,

then tighten the axle 1/4 -

1/2 turn more with a T-55

Torx wrench. Repeat for

each of the three remaining

wheels.

5. Slide the assembled arms

onto the splined T-Handle

(10) and adjust the arms

approximately ½" wider

than the ski. It may be

useful to spread the arm

clamp with a flat blade

screwdriver. Some sleds

have spindle bolts that stick

beyond the edge of the ski,

for these sleds adjust the

arms wider to avoid the

bolt (or cut the excess bolt off). The arm angle can be adjusted 15° to accommodate tall or short ski loops. Most

sleds work best at 15°. Use two ¼-20 x 1.0" (13), two ¼" washers (15), and two ¼ square nuts (14) to secure the

arms in place using the supplied 5/32" hex wrench (8). Do not overtighten. Make sure both arms are installed at

the same angle.

- Page 3 -

CI05067, rev B