Caliber 13576 조립 지침 매뉴얼 - 페이지 2

{카테고리_이름} Caliber 13576에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Caliber 13576 8 페이지. Sled wheels
Caliber 13576에 대해서도 마찬가지입니다: 조립 지침 매뉴얼 (10 페이지)

Assembly:

1. Cut the Vibratite packet (23) and empty into a disposable container. Paint the last five threads of all the bolts in

the kit (11, 12, and 13), including the axles (2). Wait ten minutes for the Vibratite to dry before proceeding with

screws.

2. Remove the arms from the T-handles, which have been installed in the storage position for shipping. Use a flat

blade screwdriver to spread the arm clamp apart if necessary to ease removal.

3. Determine which type of ski you are

using to determine the finger covers

you will use. Most snowmobile skis are

flat on the bottom, or have one or two

raised runners on the ski undersides to

help grip. The image to the right shows

the skis from the rear.

- Page 2 -

3a. For skis that are flat or have even runners, assemble the short

finger covers (16 and 17 - be sure to use the left cover on the left

arm, and right on right). Tap the rubber on a hard surface to ensure it

is fully seated. Secure with a self-tapping screw (20).

3b. For skis with uneven keels or carbides (i.e. SkiDoo Pilot skis and

others), use a finger extender (18 and 19) on the short side of the ski,

and a finger cover (16 or 17) on the long keel/carbide side. Tap the

rubber on a hard surface to ensure it is fully seated. Secure with self-

tapping screws (20). The finger extenders' height can be cut to

match your skis. Use the horizontal lines on the extenders as a guide.

This will make your Sled Wheels left or right handed, so be sure to

use them on the correct ski, or your skis will not sit flat.

CI05067, rev B