ALDON 4022-26 Buku Petunjuk - Halaman 3

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Ukur ALDON 4022-26. ALDON 4022-26 8 halaman. Spot check magnetic laser gauge and clearance measuring device

Halaman Cetak

Step 1. Turn Power On

Press the

The laser will be activated and begin taking

continuous readings.

POWER KEY

Step 2. Install the Laser On Rail

SPOT CHECK MAGNETIC LASER GAUGE

Place the

head with the foot of the laser against the gauge-face of the rail. Two

magnets will secure the

The foot of the laser's base is designed to contact the rail approximately

5/8" down from the top of the top of the rail head. It is also designed to

clear most cases of rail flow.

NOTE: When placing the laser on the rail, make sure

Step 3. Taking Measurements

Aim the

laser at the opposite rail, adjust both thumb screws until

the laser is approximately 5/8" below the top of the rail.

Aldon Company, Inc. | 847.623.8800 | [email protected] | ALDONCO.com

MEASURING TRACK GAUGE

POWER KEY

device

to the rail until adjustments are made.

both thumb screws are fully backed out.

The measurement will be displayed on

the screen. If you want/need to pause

from taking measurements, press the red

arrow key on the keypad.

RED ARROW KEY

located on the key pad.

horizontally on the rail