ALDON 4022-26 Instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przyrządy pomiarowe ALDON 4022-26. ALDON 4022-26 8 stron. Spot check magnetic laser gauge and clearance measuring device
Drukuj stronę
Step 1. Turn Power On
Press the
The laser will be activated and begin taking
continuous readings.
POWER KEY
Step 2. Install the Laser On Rail
SPOT CHECK MAGNETIC LASER GAUGE
Place the
head with the foot of the laser against the gauge-face of the rail. Two
magnets will secure the
The foot of the laser's base is designed to contact the rail approximately
5/8" down from the top of the top of the rail head. It is also designed to
clear most cases of rail flow.
NOTE: When placing the laser on the rail, make sure
Step 3. Taking Measurements
Aim the
laser at the opposite rail, adjust both thumb screws until
the laser is approximately 5/8" below the top of the rail.
Aldon Company, Inc. | 847.623.8800 | [email protected] | ALDONCO.com
MEASURING TRACK GAUGE
POWER KEY
device
to the rail until adjustments are made.
both thumb screws are fully backed out.
The measurement will be displayed on
the screen. If you want/need to pause
from taking measurements, press the red
arrow key on the keypad.
RED ARROW KEY
located on the key pad.
horizontally on the rail
3