Zanussi ZU 9155 Buklet Instruksi - Halaman 13

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Kulkas Zanussi ZU 9155. Zanussi ZU 9155 16 halaman. Zanussi instruction refrigerator zu 9155
Juga untuk Zanussi ZU 9155: Buklet Instruksi (19 halaman)

Halaman Cetak

1. Technical Specifications

BUILDING-IN INSTRUCTIONS

Before carrying out any work, remove the plug from

the power socket.

Grid preparation

Remove the grid from the appliance pulling it towards

you by hand.

Right door opening:

Remove the left side (A) of the grid cutting it from the

rear (see figure, a).

S.I.002

Left door opening:

Remove the right side (B) of the grid cutting it from

the rear (see figure, b).

S.I.001

To reposition the grid on the appliance proceed as

follows:

Apply the grid to the base of the appliance by push-

ing the clasps (a) until they click.

N.B. The grid is to be assembled after having fixed

the appliance in the niche with the brackets.

Door reversal

The appliance must be unplugged before starting

work. To reverse the opening direction of the door,

proceed as follows:

1. remove the top hinge (1) taking care not to let the

door fall;

2. remove the bottom door hinge (2).

3. take out the plugs (3) from the holes (F) and rein-

sert them in the holes (F

4. refit the upper hinge (1) on the opposite side, on

the bottom (position A);

5. refit the door on the pin of the hinge (1) in position

6. insert the pin of the unscrewed bottom hinge (2) in

the upper hole (G) of the door, therefore fix the

hinge on the top in position B.

Attention

After completion of the door reversing opera-

tion, check that the door gasket adheres to the

cabinet. If the ambient temperature is cold (i.e.

in Winter), the gasket may not fit perfectly to

the cabinet. In that case, wait for the natural fit-

ting of the gasket or accelerate this process by

heating up the part involved with a normal

hairdryer on a low setting.

Building the appliance in under a

worktop

The dimensions of the recessed installation area

must correspond

with those indicat-

ed in the figure.

The appliance

could be inserted

between two units

(a) or as an end

unit (b).

S.I.003

) on the opposite side;

S.I.004