Zanussi ZOF35702 Panduan Pengguna - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Oven Zanussi ZOF35702. Zanussi ZOF35702 24 halaman. Zanussi oven
Juga untuk Zanussi ZOF35702: Panduan Pengguna (28 halaman)

Zanussi ZOF35702 Panduan Pengguna
Removing the shelf support rails
1
Pull the front of
the shelf support rail
away from the side
wall.
Installing the shelf support rails
Install the shelf support rails in opposite se-
quence.
The rounded ends of the shelf support
rails must point to the front.
Oven door and glass panels
To clean the oven door remove it.
Caution! Be careful when you remove the
door from the appliance. The door is
heavy!
Removing the oven door
1. Open the oven door as far as it goes.
2. Lift up clamping levers (A) on the two door
hinges fully.
A
3. Close the oven door until the first position
(angle approx. 45°).
www.zanussi.com
2
Pull the rear shelf
support rail away
from the side wall and
remove it.
A
45°
4. Hold of the oven door with one hand on
each side and pull it away from the oven at
an upwards angle.
Put the oven door with the outer side
down on a soft and level surface to pre-
vent scratches.
5. Now you can remove the inner glass pan-
els and clean them.
To install the door follow the procedure in
reverse.
The oven door has 2, 3 or 4 panels of
glass (depends on the model)
Removing and cleaning the door glasses
1. Hold the door trim (B) on the top edge of
the door at the two sides and push inwards
to release the clip seal.
B
2. Pull the door trim to the front to remove it.
3. Hold the door glass panels on their top
edge one by one and pull them upwards
out of the guide
17