Zanussi ZOF35702 사용자 설명서 - 페이지 17
{카테고리_이름} Zanussi ZOF35702에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi ZOF35702 24 페이지. Zanussi oven
Zanussi ZOF35702에 대해서도 마찬가지입니다: 사용자 설명서 (28 페이지)
페이지 인쇄
Removing the shelf support rails
1
Pull the front of
the shelf support rail
away from the side
wall.
Installing the shelf support rails
Install the shelf support rails in opposite se-
quence.
The rounded ends of the shelf support
rails must point to the front.
Oven door and glass panels
To clean the oven door remove it.
Caution! Be careful when you remove the
door from the appliance. The door is
heavy!
Removing the oven door
1. Open the oven door as far as it goes.
2. Lift up clamping levers (A) on the two door
hinges fully.
A
3. Close the oven door until the first position
(angle approx. 45°).
www.zanussi.com
2
Pull the rear shelf
support rail away
from the side wall and
remove it.
A
45°
4. Hold of the oven door with one hand on
each side and pull it away from the oven at
an upwards angle.
Put the oven door with the outer side
down on a soft and level surface to pre-
vent scratches.
5. Now you can remove the inner glass pan-
els and clean them.
To install the door follow the procedure in
reverse.
The oven door has 2, 3 or 4 panels of
glass (depends on the model)
Removing and cleaning the door glasses
1. Hold the door trim (B) on the top edge of
the door at the two sides and push inwards
to release the clip seal.
B
2. Pull the door trim to the front to remove it.
3. Hold the door glass panels on their top
edge one by one and pull them upwards
out of the guide
17