Zanussi ZWT 3001 Buku Petunjuk - Halaman 14

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mesin cuci Zanussi ZWT 3001. Zanussi ZWT 3001 16 halaman. Top-loading washing machine

Halaman Cetak

3. INSTALLATION

3.1. Unpacking

Packing used to protect internal parts of the

washing machine during transport must be

removed before the washing machine is put

into service for the first time.

Remove all packing from the

washing machine. Tilt the washing

machine sideways and then remo-

ve the packing under the motor,

and straighten the washing machi-

ne.

Tilt the washing machine back-

wards, rotate it by a quarter of a

turn on one of its corner to remove

the transport base.

Open the washing machine lid and

remove the immobilization packing

and plastic films.

Close the lid.

Use a 10 mm spanner to remove

the two screws and spacers at the

back.

You can now see the openings that

must be closed with the caches in

the pack attached to the washing

machine; do not forget to fold down

the central capsule.

Make sure that you have removed

all these parts from your washing

machine and keep them so that you

can use them again if you need

them for future transport.

3.2. Position

Put the washing machine on a flat hard floor in a well ven-

tilated room.

Make sure that your washing machine does not touch the

wall or any other furniture in the room.

3.3. Moving your washing machine

3.4. Leveling

Precise leveling will prevent vibrations, noise and move-

ments of the washing machine during operation.

If you want to keep your washing

machine aligned with the adjacent

furniture, you can cut the pipe sup-

port strip at the back of your

washing machine. Leave the two

side closers in place.

If you want to move your washing

machine, lift it onto its rollers by

pulling the lever at the bottom of the

washing machine all the way to the

left. When you have put your

washing machine into the required

location, put the lever back into its

initial position.

Make the washing machine level

by adjusting the leveling screw that

is too short.

Unscrew the stand and locking col-

lar assembly (lift the washing ma-

chine if necessary).

When the washing machine is sta-

ble, maintain the stand on the

ground and turn the locking collar

as far as posible.