Zanussi ZWT 3001 Buku Petunjuk - Halaman 15

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mesin cuci Zanussi ZWT 3001. Zanussi ZWT 3001 16 halaman. Top-loading washing machine

4. Water inlet

Please install the water inlet hose onto the back of your

washing machine:

The water inlet hose cannot be extended. If it is too short,

please contact the After Sales Department.

- Assemble the hose holder onto

the drain hose.

- Place the assembly in a drainage

pipe (or in a sink) at a height

between 70 and 100 cm. Make sure

that it will not fall out.

You must provide an air intake at the end of the drainage

hose, to avoid any water being siphoned.

Important: the drainage hose must not be extended, on

any account. If it is too short, contact a qualified engineer.

You can only connect this washing machine to 230 V sin-

gle phase power supply.

Check rating of the fuse line: 10 A at 230V.

The washing machine must not be connected through an

extension cable or a power bar.

Check that the earthing connection is conform with the re-

gulations in force.

- Insert the seal in the hole at

the bottom of the back panel

(fig. 1).

- Screw on the bottom fitting of

the water inlet hose as shown

in fig. 2 and fig. 3.

- Connect the feed hose con-

nector onto the water inlet tap,

taking care to position the gas-

ket correctly.

- Turn on the water inlet tap.