Zanussi DW 920 Buklet Instruksi - Halaman 6

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Mesin pencuci piring Zanussi DW 920. Zanussi DW 920 32 halaman. Dishwasher
Juga untuk Zanussi DW 920: Buklet Instruksi (32 halaman), Buklet Instruksi (32 halaman)

Halaman Cetak

Fitting a Decor Panel on the Door

The door of this machine has frames for fitting plastic

laminate decor panel in the colour required to match

the dishwasher with the rest of the kitchen furniture. If

you want to do this you must provide this panel your¬

self.

Width; 588 mm

Height 586 mm

Max thickness: 4 mm

To Fit the Panel

• Take the door frame off after removing the retaining

screws around the edge.

• Position the panel, refit the frame and tighten the

retaining screws around the edge.

Note

The panel should be fitted before positioning the

machine.

Water Supply Connections

This dishwasher must be plumbed into a cold water

supply and it is preferable for it to be permanently

plumbed in.

The water pressure must be within the limits given in

the technical specifications, as it will not function

correctly if pressure is outside these specifications.

Your local Water Authority will advise you on the

average mains pressure in your area. Where the

water is supplied via a cold water storage cistern, you

can work out the pressure yourself by measuring the

vertical distance (or «head») between the machine's

inlet hose and the outlet from the cold water storage

cistern, allowing roughly 1 psi for every 2 feet.

As to the making of the connection itself, the coupling

nut fitted to the machine's supply hose is designed to

screw onto either a 3/4 inch gas thread spout, or to a

purpose made quick-coupling tap such as the Press-

Block.

To make this easier, the hose itself may be turned to

the left or the right. In either case, be sure to incor¬

porate the strainer A supplied with the machine onto

the joint. See picture.

Caution:

the retaining ring must be correctly fitted to

avoid water leaks.

Avoid bends or kinks in the hose which could prevent

or slow down the flow of water.

If the machine is connected to new pipes or pipes

which have not been used for a long time, you are

advised to run the water for a few minutes before

connecting the inlet hose. This will prevent deposits

of sand or rust clogging the inlet hose filter.