Zanussi DW 920 지침 책자 - 페이지 6

{카테고리_이름} Zanussi DW 920에 대한 지침 책자을 온라인으로 검색하거나 PDF를 다운로드하세요. Zanussi DW 920 32 페이지. Dishwasher
Zanussi DW 920에 대해서도 마찬가지입니다: 지침 책자 (32 페이지), 지침 책자 (32 페이지)

페이지 인쇄
Zanussi DW 920 지침 책자
Fitting a Decor Panel on the Door
The door of this machine has frames for fitting plastic
laminate decor panel in the colour required to match
the dishwasher with the rest of the kitchen furniture. If
you want to do this you must provide this panel your¬
self.
Width; 588 mm
Height 586 mm
Max thickness: 4 mm
To Fit the Panel
• Take the door frame off after removing the retaining
screws around the edge.
• Position the panel, refit the frame and tighten the
retaining screws around the edge.
Note
The panel should be fitted before positioning the
machine.
Water Supply Connections
This dishwasher must be plumbed into a cold water
supply and it is preferable for it to be permanently
plumbed in.
The water pressure must be within the limits given in
the technical specifications, as it will not function
correctly if pressure is outside these specifications.
Your local Water Authority will advise you on the
average mains pressure in your area. Where the
water is supplied via a cold water storage cistern, you
can work out the pressure yourself by measuring the
vertical distance (or «head») between the machine's
inlet hose and the outlet from the cold water storage
cistern, allowing roughly 1 psi for every 2 feet.
As to the making of the connection itself, the coupling
nut fitted to the machine's supply hose is designed to
screw onto either a 3/4 inch gas thread spout, or to a
purpose made quick-coupling tap such as the Press-
Block.
To make this easier, the hose itself may be turned to
the left or the right. In either case, be sure to incor¬
porate the strainer A supplied with the machine onto
the joint. See picture.
Caution:
the retaining ring must be correctly fitted to
avoid water leaks.
Avoid bends or kinks in the hose which could prevent
or slow down the flow of water.
If the machine is connected to new pipes or pipes
which have not been used for a long time, you are
advised to run the water for a few minutes before
connecting the inlet hose. This will prevent deposits
of sand or rust clogging the inlet hose filter.
6