Zanussi ZDT6453 Buku Instruksi - Halaman 6

Jelajahi secara online atau unduh pdf Buku Instruksi untuk Mesin pencuci piring Zanussi ZDT6453. Zanussi ZDT6453 19 halaman.

Halaman Cetak

Setting electronically

The dishwasher is factory set at level 5. If it's necessary to set

a new level, proceed as follows.

1. With the dishwasher switched off, press the On/Off push

button, all indicator lights of the programme push buttons

will illuminate (setting mode).

2. Press simultaneously function push buttons 2 and 3, the

indicator lights of the function push buttons 1, 2 and 3 start

flashing.

3. Press the function push button 1, the indicator lights of

function push buttons 2 and 3 turn off while the indicator

light of the push button 1 goes on flashing, at the same time

the "end of programme" indicator light illuminates, along

with a sequence of audible signals.

The current level is indicated by the number of flashes and

audible signals.

Example: 5 flashes + 5 audible signals = level 5

4. To change the level, press push button 1. Each time the

push button is pressed the level changes.

Examples:

if the current level is 5, by pressing push button 1 once,

level 6 is selected.

if the current level is 10, by pressing push button 1 once,

level 1 is selected.

5. To memorise the operation, switch off the dishwasher by

pressing the On/Off push button or wait about 60 seconds

after which the dishwasher will automatically return to

setting mode.

Filling with salt

Special salt can be added in one of two ways:

If you are using dishwasher detergent that already contains

salt, the detergent including the salt is placed in the

detergent compartment.

- In this case the water softener must manually be set to 1

and electronically to 1 to ensure that the special salt is

taken from the detergent container only.

If you are using dishwasher detergent and salt separately,

the special salt is to be put into the salt container.

- In this case the water softener must manually be set to 1

or 2 and electronically between 1 and 10 (depending on

the water hardness in your area) to ensure that the

special salt is taken from the salt container only.

Only use salt specifically designed for use in

dishwashers.

All other types of salt not specifically designed for use in

a dishwasher, especially table salt, will damage the water

softener.

Only fill with salt just before starting one of the washing

programmes (not the Rinse and Hold programme).

This will prevent any grains of salt or salty water, which

may have been spilt, remaining on the bottom of the

machine for any period of time, which may cause

corrosion.

To fill:

1. Open the door, remove the lower basket and unscrew the

cap of the salt container by turning it anticlockwise.

2. Pour 1 litre of water inside the container (this is necessary

only before filling with salt for the first time).

3. Using the funnel provided,

pour in the salt until the

container is full.

4. Replace the cap making

sure that there is no trace

of salt on the screw thread

or on the gasket.

5. Screw on the cap tightly

turning it clockwise until it

stops with a click.

The salt container will require topping up periodically. You are

reminded of this by the salt indicator light on the control panel

which comes on when the salt has finished.

Do not worry if water over flows from the unit when filling with

salt, this is quite normal.

The salt indicator light on the control panel can remain

illuminated for 2-6 hours after the salt has been

replenished, assuming the dishwasher remains switched

on. If you are using salts that take longer to dissolve then

this can take longer. The function of the machine is not

affected.

SR14