Zanussi ZGG 782 Buklet Instruksi - Halaman 10

Jelajahi secara online atau unduh pdf Buklet Instruksi untuk Kompor Zanussi ZGG 782. Zanussi ZGG 782 20 halaman. Zanussi gas hobs instruction booklet

Installation

IMPORTANT

This hob must be installed by a competent

person to the relevant Gas Standards.

Any gas installation must be carried out by a

registered competent person.

The manufacturer will not accept liability, should

the above instructions or any of the other safety

instructions incorporated in this book be

ignored.

Gas Connection

Connection to the gas supply should be with either rigid

or semi-rigid pipe, i.e. steel or copper.

The connection should be suitable for connecting to RC

1/2 (1/2 BSP male thread).

When the final connection has been made, it is essential

that a thorough leak test is carried out on the hob and

installation. Ensure that the main connection pipe does

not exert any strain on the hob.

It is important to install the elbow correctly, with

the shoulder on the end of the thread, fitted to the

hob connecting pipe.

Failure to ensure the correct assembly will cause

leakage of gas.

Cut Out Size

The dimensions of the cut-out are given in the diagram.

FO 2098

WHEN THE HOB IS FIRST INSTALLED

On the end of the shaft, which includes the GJ 1/2"

threaded elbow, adjustment is fixed so that the washer

is fitted between the components as shown in the

diagram. Screw the parts together without using excessive

force.

FO 0264

Rectangular cut-out size for hob

Dimensions are given in mm.

ZGG 642

FO 2038

Once the hob has been installed, it is important

to remove any protective materials, which were

put on in the factory.

A) End of shaft with nut

B) Washer

C) Elbow

FO 0814

ZGG 782