Zanussi ZGG76524 Panduan Pengguna - Halaman 27

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kompor Zanussi ZGG76524. Zanussi ZGG76524 48 halaman. Gas hob
Juga untuk Zanussi ZGG76524: Panduan Pengguna (16 halaman), Panduan Pengguna (21 halaman), Panduan Pengguna (20 halaman)

Halaman Cetak

plate rates. Make sure that you install the

plug in a correct socket.

• Always use a correctly installed shockproof

socket.

• Make sure that there is an access to the

mains plug after the installation.

• Do not pull the mains cable to disconnect

the appliance. Always pull the mains plug.

• There is a risk of fire when the appliance is in

connection with an extension cable, an

adapter or a multiple connection. Make sure

that the ground connection agrees with the

standards and regulations.

• Do not let the power cable to heat up to a

temperature higher than 90° C.

Make sure that you connect the blue

neutral cable to the terminal with a

letter "N" on it. Connect the brown

(or black) phase cable to the

terminal which has a letter "L". Keep

the phase cable connected at all

times.

Connection cable

To replace the connection cable use only the

special cable or its equivalent. The cable type

is: H05V2V2-FT90.

Make sure that the cable section is applicable

to the voltage and the working temperature. The

yellow / green earth wire must be approximately

2 cm longer than the brown (or black) phase

wire.

Building In

min.

450 mm

min.

55 mm

30 mm

480 mm

www.zanussi.com

min.

650 mm

560 mm

10 mm

3 mm

A. supplied seal

B. supplied brackets

CAUTION!

Install the appliance only on a

worktop with flat surface.

Possibilities for insertion

The panel installed below the hob must be easy

to remove and let an easy access in case a

technical assistance intervention is necessary.

Kitchen unit with door

86 mm

min 6 mm