Zanussi ZGG76524 Manual do utilizador - Página 27
Procurar online ou descarregar pdf Manual do utilizador para Hob Zanussi ZGG76524. Zanussi ZGG76524 48 páginas. Gas hob
Também para Zanussi ZGG76524: Manual do utilizador (16 páginas), Manual do utilizador (21 páginas), Manual do utilizador (20 páginas)
Imprimir página
plate rates. Make sure that you install the
plug in a correct socket.
• Always use a correctly installed shockproof
socket.
• Make sure that there is an access to the
mains plug after the installation.
• Do not pull the mains cable to disconnect
the appliance. Always pull the mains plug.
• There is a risk of fire when the appliance is in
connection with an extension cable, an
adapter or a multiple connection. Make sure
that the ground connection agrees with the
standards and regulations.
• Do not let the power cable to heat up to a
temperature higher than 90° C.
Make sure that you connect the blue
neutral cable to the terminal with a
letter "N" on it. Connect the brown
(or black) phase cable to the
terminal which has a letter "L". Keep
the phase cable connected at all
times.
Connection cable
To replace the connection cable use only the
special cable or its equivalent. The cable type
is: H05V2V2-FT90.
Make sure that the cable section is applicable
to the voltage and the working temperature. The
yellow / green earth wire must be approximately
2 cm longer than the brown (or black) phase
wire.
Building In
min.
450 mm
min.
55 mm
30 mm
480 mm
www.zanussi.com
min.
650 mm
560 mm
10 mm
3 mm
A. supplied seal
B. supplied brackets
CAUTION!
Install the appliance only on a
worktop with flat surface.
Possibilities for insertion
The panel installed below the hob must be easy
to remove and let an easy access in case a
technical assistance intervention is necessary.
Kitchen unit with door
A
86 mm
86 mm
A
B
min 6 mm
27