Zanussi ZHP 631 Panduan Pemasangan & Penggunaan - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pemasangan & Penggunaan untuk Kap Ventilasi Zanussi ZHP 631. Zanussi ZHP 631 11 halaman.
Juga untuk Zanussi ZHP 631: Buku Panduan Pemasangan, Penggunaan, dan Pemeliharaan (40 halaman), Buku Petunjuk (40 halaman)
Drilling the Support surface and Fitting the Hood
• The hood support surface must be 135 mm above
the bottom surface of the wall units.
• Drill the support with a ø 4.5 mm drill bit, using
the drilling template provided.
• Cut a hole ø 125 mm in size on the support
surface, using the drilling template provided.
• Fix using the 4 screws 12a (4,2 x 44,4) provided.
• The hood can be installed either directly on the
bottom surface of the wall units (min. 650 mm
above the hob) using snap-on side supports.
• Cut a fitted opening in the bottom surface of the
wall unit, as shown.
• Insert the hood until the side supports snap into
place.
• Lock in position by tightening the screws Vf
from underneath the hood.
13
SCREW FITTING
SNAP-ON FITTING
GB