Zanussi ZHP 631 Manuale di installazione e uso - Pagina 5

Sfoglia online o scarica il pdf Manuale di installazione e uso per Cappa di ventilazione Zanussi ZHP 631. Zanussi ZHP 631 11.
Anche per Zanussi ZHP 631: Manuale di installazione, uso e manutenzione (40 pagine), Manuale di istruzioni (40 pagine)

Drilling the Support surface and Fitting the Hood

• The hood support surface must be 135 mm above

the bottom surface of the wall units.

• Drill the support with a ø 4.5 mm drill bit, using

the drilling template provided.

• Cut a hole ø 125 mm in size on the support

surface, using the drilling template provided.

• Fix using the 4 screws 12a (4,2 x 44,4) provided.

• The hood can be installed either directly on the

bottom surface of the wall units (min. 650 mm

above the hob) using snap-on side supports.

• Cut a fitted opening in the bottom surface of the

wall unit, as shown.

• Insert the hood until the side supports snap into

place.

• Lock in position by tightening the screws Vf

from underneath the hood.

SCREW FITTING

SNAP-ON FITTING