Clarke PPH10ND Petunjuk Pengoperasian & Pemeliharaan - Halaman 7

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian & Pemeliharaan untuk Kompresor Udara Clarke PPH10ND. Clarke PPH10ND 17 halaman. Air compressor
Juga untuk Clarke PPH10ND: Panduan Pengoperasian & Pemeliharaan (10 halaman), Petunjuk Pengoperasian & Pemeliharaan (20 halaman)

Clarke PPH10ND Petunjuk Pengoperasian & Pemeliharaan

PREPARATION FOR USE

A. Environmental
Ensure the compressor is sited on a firm level surface.
Ensure the environment is dry and dust free.
Ensure there is adequate ventilation for:
a) Air intake to compressor pump
b) Cooling for compressor pump
c) Engine exhaust gases.
B. Engine
Check oil and fuel levels and a visual check of components. Refer to engine service manual.
C. Pump
Check oil level on the Dipstick - to level marked.
D. Fuelling
Fill with unleaded petrol, according to the instructions within the engine manual.
Ensure the fuel tap is set to the required position.
Ensure The fuel hose and connectors are intact, in perfectly serviceable
condition and there is no leakage.
Note : Always use a funnel to fill the fuel tank so as to avoid accidental spillage of
fuel. If fuel is spilled it must be removed from the unit and surrounding area, before
attempting to start the engine.
E. Receiver
Drain off any condensate, by opening the drain cock (see Fig. 1). Remember
to close the cock when completed.
NOTE: This should be carried out DAILY when the compressor is in constant use.
F. Air Hose & Air Tool
Attach the air hose to the outlet using an appropriate connector.
NOTE: Quick fit nuts are provided. These may be removed if a 1/4"BSP is required.
Attach the air tool/spray gun to the air hose...If using snap couplings, use
a whip end, available from your Clarke dealer.
- 7 -