Directed Xpresskit DBALL2 Panduan Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Dengan kunci Directed Xpresskit DBALL2. Directed Xpresskit DBALL2 13 halaman. Ford5 remote start ready (rsr) installation
Juga untuk Directed Xpresskit DBALL2: Panduan Instalasi (12 halaman), Panduan Instalasi (19 halaman), Panduan Instalasi (18 halaman), Manual (14 halaman), Panduan Instalasi (14 halaman), Panduan Instalasi (19 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (20 halaman), Panduan Instalasi (15 halaman), Panduan Instalasi dan Referensi Cepat (16 halaman), Panduan Instalasi (18 halaman), Panduan Instalasi (16 halaman), Panduan Instalasi (18 halaman), Panduan Instalasi (16 halaman), Manual (19 halaman)

Halaman Cetak

Directed Xpresskit DBALL2 Panduan Instalasi

Platform: DBALL2

Firmware: CHRYSLER6

Installation with T-Harness THCHD3

T-02:

Dodge RAM 1500

Only

Note: The BCM is located in the driver

BCM

side dash, above the kick panel.

(Connector B)

(+) 12V:

Red, pin 3

BCM

(White Connector F)

(-) Driver Door Trigger:

Violet, pin 9

Parking Lights:

White/Brown, pin 20

Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

[1]

With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).

Keyless

Ignition Node

(+) 12 V

(AC) Tach Input

[1]

(MUX) Parking Lights Output: Violet/Brown

BCM

(Blue Connector G)

These T-Harness connectors are

NOT interchangeable. They will fit

ONLY the appropriate vehicles.

T-01

6-pin Black

Connector

Keyless

Ignition Node

(Optional T-Harness)

(+) Ignition Input

(+)Ignition Output: Yellow/Red

(-) (AC) Tach Output: Violet/White

[1]

(-) RAP Off: Orange/Black

Diagnostic 16-pin Connector

THCHD3 Rev. 1

Remote Start Safety

Override Switch

Prog.Button

DBALL2

LED

Rev.: 20151029

Page 4

OBDII