Directed Xpresskit DBALL2 Kurulum Kılavuzu - Sayfa 4

Kilitler tarafından Directed Xpresskit DBALL2 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Directed Xpresskit DBALL2 13 sayfaları. Ford5 remote start ready (rsr) installation
Ayrıca Directed Xpresskit DBALL2 için: Kurulum Kılavuzu (12 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (18 sayfalar), Manuel (14 sayfalar), Kurulum Kılavuzu (14 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (15 sayfalar), Kurulum ve Hızlı Referans Kılavuzu (16 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (16 sayfalar), Manuel (19 sayfalar)

Sayfayı Yazdır

Directed Xpresskit DBALL2 Kurulum Kılavuzu

Platform: DBALL2

Firmware: CHRYSLER6

Installation with T-Harness THCHD3

T-02:

Dodge RAM 1500

Only

Note: The BCM is located in the driver

BCM

side dash, above the kick panel.

(Connector B)

(+) 12V:

Red, pin 3

BCM

(White Connector F)

(-) Driver Door Trigger:

Violet, pin 9

Parking Lights:

White/Brown, pin 20

Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

[1]

With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).

Keyless

Ignition Node

(+) 12 V

(AC) Tach Input

[1]

(MUX) Parking Lights Output: Violet/Brown

BCM

(Blue Connector G)

These T-Harness connectors are

NOT interchangeable. They will fit

ONLY the appropriate vehicles.

T-01

6-pin Black

Connector

Keyless

Ignition Node

(Optional T-Harness)

(+) Ignition Input

(+)Ignition Output: Yellow/Red

(-) (AC) Tach Output: Violet/White

[1]

(-) RAP Off: Orange/Black

Diagnostic 16-pin Connector

THCHD3 Rev. 1

Remote Start Safety

Override Switch

Prog.Button

DBALL2

LED

Rev.: 20151029

Page 4

OBDII