Directed Xpresskit DBALL2 Kurulum Kılavuzu - Sayfa 3

Kilitler tarafından Directed Xpresskit DBALL2 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Directed Xpresskit DBALL2 13 sayfaları. Ford5 remote start ready (rsr) installation
Ayrıca Directed Xpresskit DBALL2 için: Kurulum Kılavuzu (12 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (18 sayfalar), Manuel (14 sayfalar), Kurulum Kılavuzu (14 sayfalar), Kurulum Kılavuzu (19 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (20 sayfalar), Kurulum Kılavuzu (15 sayfalar), Kurulum ve Hızlı Referans Kılavuzu (16 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (16 sayfalar), Kurulum Kılavuzu (18 sayfalar), Kurulum Kılavuzu (16 sayfalar), Manuel (19 sayfalar)

Sayfayı Yazdır

Directed Xpresskit DBALL2 Kurulum Kılavuzu

Platform: DBALL2

Firmware: CHRYSLER6

Installation without T-Harness

Note: The BCM is located in the driver side dash, above the kick panel.

Diagnostic Connector

CAN IHS High: Gray, pin 3

[2]

CAN IHS Low

[2]

White, pin 11

CAN C Low:

Yellow, pin 14

(-) Ground

Immo. Data:

White/Lt Green: pin 5

(+) 5V Ignition:

Violet/Brown,

pin 4

Ignition Node

(black connector)

Not required in D2D mode.

Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.

[1]

DBALL2 Only. Required for heated seats.

[2]

With the exception of the OBDII Diagnostic connector, all adapters are displayed from the wire side (unless specified otherwise).

(-) E-Brake Status Input

OBDII

CAN C High: Gray/White, pin 6

HS CAN High: Tan/Black: 3

HS CAN Low: Tan: 4

HS CAN2 High: Orange/Green: 5

[2]

HS CAN2 Low: Orange/Brown: 6

[2]

Immo. Data (conn. side): Yellow: 8

Immo. Data (veh.side): Orange/Yellow: 9

Ignition Status Output: Yellow/Red: 11

(+) 12V: Brown/Red: 12

(+) 12V: Red: 13

(+) 12V

(-) Ground: Black: 14

(-) E-Brake Output: Black/White: 1

(-) Door Status Output: Green/White: 3

(-) Trunk Status Output: Red/Black: 4

(-) (AC) Tach Output: Violet/White: 5

[1]

(+) Brake Output: Gray: 6

(+) Ignition Output: Gray/Black: 7

(MUX) Parking Light Output: Violet/Brown: 9

Immo. Data (veh.side): Yellow/Black: 10

(-) RAP Off: Orange/Black: 11

(-) Hood Status Output: Blue/Red: 12

BCM

(Blue Connector G)

(-) Hood Input

(+) Brake Input

(AC) Tach Input

[1]

(-) Trunk Status Input

(-) Door Status Input

(+) Ignition Input

Prog.Button

DBALL2

LED

Parking Lights Input: White/Brown, pin 20

(-) Driver Door Trigger: Violet, pin 9

Rev.: 20151029

(+) 12V: Red, pin 3

BCM

(+) 12 V

(Connector B)

(-) Lock Output

(-) Unlock Output

(+) Parking Light Output

(+) Starter Output

(-) GWR (Status)

10: Blue/White: (-) GWR (Status) Input

9: Pink: (+) Ignition Input

8: Violet: (+) Starter Input

7: Pink/White: (+) Parking Light Input

2: Blue: (-) Unlock Input

1: Green: (-) Lock Input

(+)12V

(-) Ground

P#: XKD2D65

BCM

(White Connector F)

Page 3

(-) Ground