aerauliqa CTRL-XWS Buku Petunjuk - Halaman 19

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pengontrol aerauliqa CTRL-XWS. aerauliqa CTRL-XWS 20 halaman.

5.2.7 SETTING OF THE CONSTANT DATA

Press contemporaneously

Four lines are shown on the display and then the message CONF. is displayed.

Press

to scroll the setting menu.

Parameters:

P.r.o.b.

Cor.1. = ceiling temperature probe correction

Cor.2. = ground temperature probe correction

SCAL = °C/°F Celsius or Fahrenheit degree

Air

SP.Lo = % of minimum speed

SP.Hi = % of the maximum speed

P.b.Su. = proportional band of regulation in summer mode

P.b.Vi. = proportional band of regulation in winter mode (destratification)

t.Lo.A = minimum temperature alarm value

t.Hi.A = maximum temperature alarm value

d.SE.t = temperature alarm relays hysteresis

t.on.v.= on time (active) for ventilation timing (t.on=0 constant ventilation)

T.of.v.= off time (pause) for ventilation timing (t.off=0 constant ventilation)

t.Int.= 0-10V integration time

Star = % minimum starting speed

5.3 MEMORY OF THE REGISTERED TEMPERATURE (the values are retained even with the controller switched off)

Press

: the diagram is displayed followed by the maximum registered temperature value. Keeping

CLEA. is shown and the memory is cleared.

Press

: the diagram is displayed followed by the minimum registered temperature value. Keeping

CLEA. is shown and the memory is cleared.

5.4 SYSTEM RESET

Disconnect the controller from the main power supply.

Connect the controller to the main power supply and keep

Release

and wait for the reset.

Attention: Any setting will return to the default.

and

for about 5 seconds.

pressed until the word BOOT is displayed.

pressed for more than 3 seconds, the word