Clarke CAT220 3110474 Panduan Petunjuk Pengoperasian dan Pemeliharaan - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian dan Pemeliharaan untuk Sander Clarke CAT220 3110474. Clarke CAT220 3110474 17 halaman. 3”
Halaman Cetak
You can fit a whip hose with a quick fit coupling if required (available from
your CLARKE dealer).
FITTING THE BACKING DISC
Insert the spindle locking pin through
the aperture provided and into the
hole in the drive spindle to stop the
spindle from rotating.
Thread the backing disc into the
drive spindle by turning it clockwise.
Tighten the disc using the locking pin
provided to prevent the drive shaft
from rotating.
ATTACHING THE PAD OR MOP
1. Select your attachment (either lambswool mop or sponge pad). Line up
and centre your choice of attachment to the backing disc.
2. Press either the sponge pad or mop against the backing disc so that the
hook and eye surfaces engage. Run your hand over the surface to ensure
it is affixed.
OPERATION
RUNNING THE TOOL
The polisher should run at a suitable
speed which can be regulated as
required by turning the regulator.
• The regulator turns through 90
degrees between fully on and
fully off.
1. Squeeze the trigger against the
body of the tool to run.
2. Release the trigger to stop the
tool.
• The tool will continue to rotate very briefly after the trigger has been
released.
3. ALWAYS ensure the tool has stopped before putting it down.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8