Clarke CAT220 3110474 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke CAT220 3110474에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CAT220 3110474 17 페이지. 3”

You can fit a whip hose with a quick fit coupling if required (available from

your CLARKE dealer).

FITTING THE BACKING DISC

Insert the spindle locking pin through

the aperture provided and into the

hole in the drive spindle to stop the

spindle from rotating.

Thread the backing disc into the

drive spindle by turning it clockwise.

Tighten the disc using the locking pin

provided to prevent the drive shaft

from rotating.

ATTACHING THE PAD OR MOP

1. Select your attachment (either lambswool mop or sponge pad). Line up

and centre your choice of attachment to the backing disc.

2. Press either the sponge pad or mop against the backing disc so that the

hook and eye surfaces engage. Run your hand over the surface to ensure

it is affixed.

OPERATION

RUNNING THE TOOL

The polisher should run at a suitable

speed which can be regulated as

required by turning the regulator.

• The regulator turns through 90

degrees between fully on and

fully off.

1. Squeeze the trigger against the

body of the tool to run.

2. Release the trigger to stop the

tool.

• The tool will continue to rotate very briefly after the trigger has been

released.

3. ALWAYS ensure the tool has stopped before putting it down.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]