Alelion 1003220 Panduan Pengguna - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori Kamera Alelion 1003220. Alelion 1003220 16 halaman. Lithium ion battery

Storage

Please note as all batteries the EasyPower battery has a certain self-discharge, this is mainly

due to power consumption of the inbuilt security system. Never store an EasyPower battery

that indicates or warns that the SOC is low, it should be charged at first given opportunity.

Store less than four (4) weeks; no special consideration needed, the battery should not risk

going to protect* due to self-discharge during this timeframe.

Store more than four (4) weeks; charge until full before the lift truck / EasyPower battery is

put in to storage. Follow this to avoid ending up in protect* mode due to the self-discharge

earlier then needed. Before it is put back in to use, charge again if needed.

*(See the subsection Troubleshooting/Protect Mode)

Control a stored EasyPower battery at least every sixth (6) month and charge if SOC <50%.

Driving

Always use lift truck according to the manufacturer's instructions. Normal operation should

not be any different for the operator until the EasyPower battery is almost empty. This will

be communicated to the lift truck and it will initiate various limitation actions. This can be as

an example; limited acceleration and/or lower lifting speed. When this occurs you are

driving on the last reserve and therefore should stop working and recharge your Easy Power

Battery.

For more specific information regarding the lift truck limitations when battery capacity

reaches the end, please refer to lift truck user manual.

Maintenance

Maintenance is only allowed to do be done by instructed personnel that have knowledge of

batteries with high energy content.

Once a week:

Control that the charging connections are undamaged.

Clean if needed, the EasyPower battery shall only be wiped off when cleaning.

Never use flowing water or high pressure cleaning.

Once a month:

Let the charger be connected to the EasyPower battery until it indicates battery

fully charged, at least once a month to keep it balanced*.

*(After a while with incomplete charging and loading cycles the need for balancing

might occur. This will ensure that all cells are fully charged and that you have all the

capacity at your disposal. The balancing is automatic and is done if needed with help of

the charger, at the end of the charging cycle.)

Remaining maintenance shall be done by service personnel at occasions that follows

ordinary service schedule for the lift truck.

2016-06-09, 1004070-001