Directed Electronics 550.6 Panduan Pemilik - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Penguat Directed Electronics 550.6. Directed Electronics 550.6 16 halaman. Directed electronics, inc power amplifier owner's manual
Halaman Cetak
FRONT PANEL CONNECTIONS/STATUS LED
1. R R C C A A I I n n p p u u t t J J a a c c k k s s - Accepts line level
outputs from head units or signal
processors at voltages between
150mV and 8 volts.
2. R R C C A A O O u u t t p p u u t t J J a a c c k k s s - These pass
through RCA jacks can be used to
send a signal to a second amplifier. It
is the summed stereo output of the
one through four channel inputs of
the amplifier.
3. S S t t a a t t u u s s L L E E D D - Lights GREEN to indi-
cate the amplifier is on and oper-
ating normally, and will be off if the
FIGURE 1—AMPLIFIER CONNECTIONS 550.6 FRONT
8
4. R R e e m m o o t t e e S S u u b b L L e e v v e e l l C C o o n n t t r r o o l l - Controls
W W a a r r n n i i n n g g : : DO NOT connect a level control knob from other
1
2
amplifier shuts down due to short
circuit, DC offset, or overheating
detected by the on-board protection
circuitry.
the gain of channels five and six
from a remote location for ease of
adjustment during listening.
manufacturers to the Remote Sub Level Control of
any Viper amplifier. Even though the connectors fit
properly, the control knob and connector pin posi-
tions may be different and the amplifier will be
damaged.
3
4
© 2002 Directed Electronics, Inc