- ページ 8

アンプ Directed Electronics 550.6のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Directed Electronics 550.6 16 ページ。 Directed electronics, inc power amplifier owner's manual

ページを印刷する

FRONT PANEL CONNECTIONS/STATUS LED

1. R R C C A A I I n n p p u u t t J J a a c c k k s s - Accepts line level

outputs from head units or signal

processors at voltages between

150mV and 8 volts.

2. R R C C A A O O u u t t p p u u t t J J a a c c k k s s - These pass

through RCA jacks can be used to

send a signal to a second amplifier. It

is the summed stereo output of the

one through four channel inputs of

the amplifier.

3. S S t t a a t t u u s s L L E E D D - Lights GREEN to indi-

cate the amplifier is on and oper-

ating normally, and will be off if the

FIGURE 1—AMPLIFIER CONNECTIONS 550.6 FRONT

4. R R e e m m o o t t e e S S u u b b L L e e v v e e l l C C o o n n t t r r o o l l - Controls

W W a a r r n n i i n n g g : : DO NOT connect a level control knob from other

amplifier shuts down due to short

circuit, DC offset, or overheating

detected by the on-board protection

circuitry.

the gain of channels five and six

from a remote location for ease of

adjustment during listening.

manufacturers to the Remote Sub Level Control of

any Viper amplifier. Even though the connectors fit

properly, the control knob and connector pin posi-

tions may be different and the amplifier will be

damaged.