Clarke CCO14B Panduan Petunjuk Pengoperasian & Pemeliharaan - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian & Pemeliharaan untuk Melihat Clarke CCO14B. Clarke CCO14B 17 halaman. Abrasive cut-off saw

Halaman Cetak

MAINTENANCE AND SERVICING

WARNING: BEFORE PERFORMING ANY MAINTENANCE TASKS ENSURE THE

PLUG HAS BEEN REMOVED FROM THE MAINS SUPPLY.

Before use, always check the condition of the abrasive disc to ensure there

are no cracks or badly pitted edges. If in doubt, renew the wheel.

CHANGING THE ABRASIVE DISC

IMPORTANT: Ensure the replacement disc is rated above the rated speed of

the machine.

Having disconnected the power supply, Raise the

Upper Blade Guard by hand as high as possible,

then slide the bar, arrowed in fig.6, across, so that it

retains the Blade Guard in place as shown.

Slacken off the two screws which secure the

abrasive disc centre bolt access plate shown in fig

6, and remove the plate.

Using the 8mm hex. wrench, undo and remove the

abrasive disc centre bolt, then remove the washer

and flange. Finally, carefully remove the abrasive

disc.

Reassemble in reverse order, ensuring the disc and

flange are correctly mounted on the flats on the

shaft with the flange and washer oriented as

shown in fig.7, Take great care not to over tighten

the centre bolt.

Refer to your CLARKE dealer if internal

maintenance is required.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]