Clarke CCO14B Panduan Petunjuk Pengoperasian & Pemeliharaan - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian & Pemeliharaan untuk Melihat Clarke CCO14B. Clarke CCO14B 17 halaman. Abrasive cut-off saw
Halaman CetakADJUSTING THE VICE
A. BEVEL CUTTING
The vice may be moved up to 45° for
bevel cutting.
To set the required angle, slacken off
the two bolts securing the fixed vice
jaw (shown at B), and swivel the jaw
to the appropriate angle according
to the scale provided. Use a set
square or angle gauge set against
the abrasive disc if absolute
accuracy is required. Tighten the two
securing bolts when satisfied.
B. POSITIONING THE FIXED VICE JAW
The fixed jaw may be fixed in one of
three positions to accommodate
larger workpieces.
Undo and remove the two screws
securing the jaw and reposition as
desired, using the bolt holes arrowed
in Fig.5 to secure the jaw.
OPERATION
Ensuring the workpiece is properly clamped and observing all precautions
previously mentioned, switch ON by pressing the safety lock button before
pulling the ON/OFF trigger switch upwards. Allow the wheel to reach full speed
then gently lower it on to the work. DO NOT try to cut too harshly.
The switch is a 'dead man' type and the motor will stop when it is released.
NOTE: Take great care when cutting with a new wheel. DO NOT press too
heavily particularly at the end of a cut.
9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]