Clarke 3110462 Petunjuk Pengoperasian & Pemeliharaan - Halaman 8
Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian & Pemeliharaan untuk Peralatan Clarke 3110462. Clarke 3110462 17 halaman. Punch & flange tool
Halaman Cetak
OPERATION
1. Connect the tool to the air supply.
2. To start the tool, hold firmly and squeeze the throttle lever.
• The clamp will move down, punching a hole or forming a flange, as
required.
3. Release the lever and the clamp will rise allowing the tool to be positioned
for the next operation.
4. After use, disconnect the tool from the air supply, clean and store in a safe,
dry, childproof location.
NOTE: It is recommended that a whip hose with a swivel (not included)
be used to prevent twisting, kinking and resultant wear to the air
hose.
DISCONNECTING THE AIR SUPPLY
Do not disconnect the air supply hose until the compressor has been shut
down and the compressed air released.
1. Refer to the compressor instruction manual for the procedure to shut down
and release the compressed air.
2. Once the pressure has been released, disconnect the air supply hose from
the air tool.
3. Store the tool safely in its box in a dry, secure environment.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8