Clarke 3110462 운영 및 유지 관리 지침 - 페이지 8

{카테고리_이름} Clarke 3110462에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 3110462 17 페이지. Punch & flange tool

OPERATION

1. Connect the tool to the air supply.

2. To start the tool, hold firmly and squeeze the throttle lever.

• The clamp will move down, punching a hole or forming a flange, as

required.

3. Release the lever and the clamp will rise allowing the tool to be positioned

for the next operation.

4. After use, disconnect the tool from the air supply, clean and store in a safe,

dry, childproof location.

NOTE: It is recommended that a whip hose with a swivel (not included)

be used to prevent twisting, kinking and resultant wear to the air

hose.

Do not disconnect the air supply hose until the compressor has been shut

down and the compressed air released.

1. Refer to the compressor instruction manual for the procedure to shut down

and release the compressed air.

2. Once the pressure has been released, disconnect the air supply hose from

the air tool.

3. Store the tool safely in its box in a dry, secure environment.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]