Clarke 3110462 운영 및 유지 관리 지침 - 페이지 10

{카테고리_이름} Clarke 3110462에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 3110462 17 페이지. Punch & flange tool

If the tool becomes inefficient and the air supply is of good quality, it may be

necessary to replace worn or damaged parts. You may prefer to take the tool

to your Clarke dealer if internal maintenance is required.

PERFORMANCE

Please note that factors other than the tool may effect its operation and

efficiency such as reduced compressor output, excessive drain on the airline,

moisture or restrictions in the air-line, or the use of connectors of improper size

or poor condition which will reduce air supply.

**Clarke Air-lne Oil (part no. 3050825) is available from your Clarke dealer.

Your Clarke air tool has been designed to give long and trouble free service. If,

however, having followed the instructions in this booklet carefully, you

encounter problems, take the unit to your local Clarke dealer.

STORAGE

If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of

Clarke air-line oil into the air inlet, and depress the trigger in order to lubricate

the internal parts.

When not in use, disconnect from air supply, clean and store in a safe, dry

place.

ACCESSORIES

A wide range of airline accessories is available including filter/regulators,

lubricators, high-pressure hoses (5 to 50 metres) etc.

Contact your Clarke dealer or Clarke International Service Department for

further information.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]