CLAS OE 6047 Manual - Halaman 14

Jelajahi secara online atau unduh pdf Manual untuk Alat Listrik CLAS OE 6047. CLAS OE 6047 16 halaman. Hot air gun 50-650 c

OE 6047

ACCESSOIRES

Description

Protective nozzle

Welding nozzle

Reduction nozzle

Re ective nozzle

Scraper

Warning

• Make sure that the tool is switched off and the nozzle has cooled down.

• Falling down nozzle can set an object on re. Nozzles must be mounted rmly and secure on the unit.

• Touching a hot nozzle can lead to serious burns. Before attaching or replacing a nozzle, allow the unit to cool

down completely or use a suitable tool.

• A hot nozzle can set a surface on re. Place down hot nozzles only on re-proof surfaces.

• An incorrect or defective nozzle can lead to heat accumulation and damage the unit. Use only original nozzles

according to the table that are suitable for your unit.

INSTRUCTIONS

• Always observe the safety instructions and applicable regulations.

• Use only one hand to hold the tool, do not place your other hand over the air vents

Prior to operation :

•Mount the correct accessory for the application.

•Set the desired air temperature

Switching on and off

• To switch the tool on, set the on/off switch to position 1/2. Some smoke may be emitted after switching on; this

does not indicate a problem.

• To switch the tool off, adjust the lowest temperature to cool off, then set the on/off switch to position 0. Let the

tool cool down before moving or storing it.

HOT AIR GUN 50-650°C

Purpose

Protection windows when stripping frames

Dying, thawing (heat spread over wider area)

Welding, shrink sleeving (heat concentrated over small area)

Soldering pipes

Stripping paint and varnish

clas-equipements.com