Nikon E800 Panduan Petunjuk Pengoperasian - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Mikroskop Nikon E800. Nikon E800 9 halaman.
Juga untuk Nikon E800: Buku Petunjuk (42 halaman), Petunjuk Manual (22 halaman)
Halaman Cetak
Turning on the Microscope:
1) Sign in on the log sheet.
2) Turn on the main power and the camera power.
3) Turn the microscope power to "on".
4) Turn on the Fluorescence power only if you plan to use fluorescence imaging.
Please note: fluorescence bulb needs `30MIN to warm up to full illumination. It also
needs 30 MIN to cool after to has been turned off before it can be turned on again.
PLEASE OBSERVE THESE TIME REQUIREMENTS TO PRESERVE THE
BULB!!
5) The computer is normally left ON. Just wake up the monitor and open the SPOT
ADVANCED software.
Turning off the microscope
1) Power off all switches (except computer)
NOTE: make sure the next user does not plan to use it before turning of fluorescence
Burner. All users should put an "F" on the sign-up sheet if they need fluorescence so the
previous user knows to leave the burner on. You must be on time for your session, as the
previous user MUST turn off the microscope completely before they leave and they will
not wait for you. Once the burner if off, you must wait 30min before turning it on again.
2) Move objective turret to 2x or 10X position.
3) Leave condenser in position "A".
4) Leave DIC upper filter in the OUT position.
5) Clean off immersion oil from objectives using lens paper if necessary.
6) Log off computer.
7) Make sure all your
are removed and area is
8) Turn off all room lights.
Microscope
Power
2
supplies
left clean.
Main
P ower
Camera
P ower
Fluorescence
Burner