- ページ 2

顕微鏡 Nikon E800のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Nikon E800 9 ページ。
Nikon E800 にも：取扱説明書 (42 ページ), 取扱説明書 (22 ページ)

Turning on the Microscope:

1) Sign in on the log sheet.

2) Turn on the main power and the camera power.

3) Turn the microscope power to "on".

4) Turn on the Fluorescence power only if you plan to use fluorescence imaging.

Please note: fluorescence bulb needs `30MIN to warm up to full illumination. It also

needs 30 MIN to cool after to has been turned off before it can be turned on again.

PLEASE OBSERVE THESE TIME REQUIREMENTS TO PRESERVE THE

BULB!!

5) The computer is normally left ON. Just wake up the monitor and open the SPOT

ADVANCED software.

1) Power off all switches (except computer)

NOTE: make sure the next user does not plan to use it before turning of fluorescence

Burner. All users should put an "F" on the sign-up sheet if they need fluorescence so the

previous user knows to leave the burner on. You must be on time for your session, as the

previous user MUST turn off the microscope completely before they leave and they will

not wait for you. Once the burner if off, you must wait 30min before turning it on again.

2) Move objective turret to 2x or 10X position.

3) Leave condenser in position "A".

4) Leave DIC upper filter in the OUT position.

5) Clean off immersion oil from objectives using lens paper if necessary.

6) Log off computer.

7) Make sure all your

are removed and area is

8) Turn off all room lights.

Microscope

Power

supplies

left clean.

Main P ower

Camera P ower

Fluorescence

Burner