Nikon Callaway XHOT Buku Petunjuk - Halaman 7
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Ukur Nikon Callaway XHOT. Nikon Callaway XHOT 17 halaman.
Halaman Cetak
Operational Summary
Caution-use of controls or adjustments or performance of procedures other than those specified herein may
result in hazardous radiation exposure
1. Install a battery in the battery chamber. (See
"Changing
Batteries")
2. Rubber eyepiece cup
Eyeglass
wearer:
Collapse the
eyepiece
cups.
Non-eyeglass
wearers:
Do not collapse the eyepiece cups.
3. Diopter adjustment
Adjust diopter to obtain a clear image in the LCD.
First, rotate the diopter
adjustment
ring counterclockwise until it
comes
to a complete
stop.
Next, turn on the power to
activate
the
LCD
when
you look through the Laser Rangefinder. Rotate the diopter adjustment ring clockwise until the display comes into
focus.
If the diopter is not adjusted to correspond to your eyesight, you may not be able to clearly focus your subject.
4.
Measuring
Note: Depressing
and
holding down the POWER button
causes
all
symbols
to be displayed in the LCD panel. After you remove your finger
from the POWER button, the last-used setting is displayed. (If
you
briefly press the POWER button then remove
your
finger, the LCD panel
may display the last-used
setting without
displaying all of the symbols. This is not a malfunction or other problem.)
Before measuring, be sure to confirm unit
setting.
8
seconds
pass
without
operation
*
Power
off:
LCD indications disappear.
I
J
*
Power turns off B seconds after the last operation.
1:.r
[Continuous measurement mode)
For continuous
measurement mode
(for 8 seconds)
IPOWEAI Depressing the POWER button
allows
you to perform continuous measurement for 8
seconds.
The Laser Rangefinder doesn't have a single measurement function
.
Blinks while performing measurements.
When measuring a pin at a golf course, for
example,
use the continuous measurement mode for
easy measurement. With no objects between you and the pin, the Laser Rangefinder measures
the distance to your targeted pin.
5.
Selecting display unit (default setting is yards.)
r
Meter[ml
~
Yard[YDI
~
1. Confirm the internal LCD panel is on.
2. Press
and
hold the MODE button (more
than
two
seconds.)
3. When display unit has switched, release the MODE button.
4. Repeat steps 2 and 3 until your desired mode is
displayed.
5. When you have completed setting, results will be converted and displayed in the your
selected
measurement unit.
6. Distance display
The Laser Rangefinder has a First Target Priority System. When measuring overlapping subjects, this equipment displays the distance
to the closest subject.
7. Low battery indication
Flashing
~
indicates that the battery charge is low and battery
should
be replaced. (See
"Changing
Battery")