Disaster Area Designs Qconnect Panduan Pengguna - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Peralatan Perekaman Disaster Area Designs Qconnect. Disaster Area Designs Qconnect 16 halaman. Multi output midi controller

Halaman Cetak

ondi

edal

etup

uide

To configure your Bondi Art Van Delay pedal with qCONNECT, plug in a TS / mono cable from

one of the ports on qCONNECT to the AUX jack on the left side of the Bondi pedal.

Enter Setup on the qCONNECT and configure the port you're using as TIP or MID.T.

Set your desired device mode to ARTV. Remember to hold the right footswitch to save.

Example: If you want to use the Art Van as your second MIDI device connected to

Port B, you would set DevB = ARTV, CFG.B = TIP in the

qCONNECT Setup menu.

Power the qCONNECT on, but leave the Bondi

pedal off.

Hold and release the right footswitch on the qCONNECT until the device mode that you want to

use is showing.

Example: To use the Art Van as the second device, navigate to the B device mode - B

plus a number will show.

Power on the Art Van delay while holding

down its tap tempo footswitch. Release the

tap switch when you see the LEDs on the

Bondi pedal fading on and

off.

Press and release the tap tempo footswitch on the Art Van until the white LED flashes 4 times

quickly. That indicates that the AUX jack on the Bondi is set to receive MIDI.

Hold both buttons on the

Art Van to save the

settings and exit.

Power the Art Van off and back on while holding the tap tempo footswitch. Release when its

two LEDs fade on and off.

Tap the left or right buttons on the qCONNECT until you see the pink LED on the Art Van flash.

Hold both footswitches on the Art Van to save.

Your Art Van Delay is now configured!