Disaster Area Designs Qconnect Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Обладнання для запису Disaster Area Designs Qconnect. Disaster Area Designs Qconnect 16 сторінок. Multi output midi controller

B
p
s
g
ondi
edal
etup
uide
To configure your Bondi Art Van Delay pedal with qCONNECT, plug in a TS / mono cable from
one of the ports on qCONNECT to the AUX jack on the left side of the Bondi pedal.
Enter Setup on the qCONNECT and configure the port you're using as TIP or MID.T.
Set your desired device mode to ARTV. Remember to hold the right footswitch to save.
Example: If you want to use the Art Van as your second MIDI device connected to
Port B, you would set DevB = ARTV, CFG.B = TIP in the
qCONNECT Setup menu.
Power the qCONNECT on, but leave the Bondi
pedal off.
Hold and release the right footswitch on the qCONNECT until the device mode that you want to
use is showing.
Example: To use the Art Van as the second device, navigate to the B device mode - B
plus a number will show.
Power on the Art Van delay while holding
down its tap tempo footswitch. Release the
tap switch when you see the LEDs on the
Bondi pedal fading on and
off.
Press and release the tap tempo footswitch on the Art Van until the white LED flashes 4 times
quickly. That indicates that the AUX jack on the Bondi is set to receive MIDI.
Hold both buttons on the
Art Van to save the
settings and exit.
Power the Art Van off and back on while holding the tap tempo footswitch. Release when its
two LEDs fade on and off.
Tap the left or right buttons on the qCONNECT until you see the pink LED on the Art Van flash.
Hold both footswitches on the Art Van to save.
Your Art Van Delay is now configured!
10