Blade Blade 180QX HD Buku Petunjuk - Halaman 14

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Quadcopters Blade Blade 180QX HD. Blade Blade 180QX HD 20 halaman.
Juga untuk Blade Blade 180QX HD: Buku Petunjuk (20 halaman)

Halaman Cetak

Installation

1. Install the included hook and loop tape on the bottom of

the camera, as shown.

2. Install the camera on the model using the included hook

and loop strap.

3. Connect the servo lead from the main board to the

camera servo lead port.

4. Press the camera power button. The red LED will glow

solid during initialization, then turn off. The blue LED will

glow solid.

Changing Modes

The camera comes from the factory in still mode. To

change between video and still mode, press and hold the

trigger. When changing to video mode, the blue LED will

blink twice. When changing back to still mode, the blue

LED will blink once.

Operation

To use the camera, press and release the trigger on the

back of the RTF transmitter. This will take a picture or start

recording video. Press the trigger again to stop recording

video. When taking a picture, the blue LED will blink once

and return to solid. When recording video, the blue LED will

blink slowly and return to solid when ﬁ nished recording.

BNF Transmitters

To use the camera function with other transmitters, assign

channel 6 to a momentary switch/button on your transmit-

ter. The switch/button will function the same as the RTF

trigger.

The camera also functions manually through the buttons.

Data Retrieval

Data from the camera can be retrieved through the micro

USB port or the removable 2GB TF micro SD card.

Flight Mode Calibration

• It may not be necessary to do both calibrations.

• If the quadcopter is drifting only in Agility Mode, then follow the Agility Mode Calibration instructions.

• If the quadcopter is drifting only in Stability Mode, then follow the Stability Mode Calibration instructions.

• As there is no GPS, there may always be a small amount of drift in any ﬂ ight mode.

• There is no self-leveling during calibration. It is up to the pilot to bring the quadcopter to a stable hover.

Agility Mode Calibration

1. Ensure all trims are centered.

2. Power on the transmitter and move the throttle stick to full throttle.

3. Ensure the transmitter is in Agility Mode.

4. Hold full down elevator.

5. Connect the fully charged ﬂ ight battery in the quadcopter.

6. Both LEDs will ﬂ ash. Leave the throttle at full and return the elevator to center.

7. Leave the quadcopter still until the LEDs ﬂ ash red then blue. This can take up to 30 sec-

onds or more. When the LEDs repeat with one blink per color, the calibration is complete.

8. If only the red LED is ﬂ ashing, the calibration has failed. Repeat the process.

9. Disconnect the battery.

Full down elevator