Discount Car Stereo IL-JAG98 Panduan Instalasi Mulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Instalasi Mulai Cepat untuk Sistem Stereo Mobil Discount Car Stereo IL-JAG98. Discount Car Stereo IL-JAG98 6 halaman. Apple lightning for 1997-06 xk (x100) and 1998-03 xj (x308) with cd changer

Halaman Cetak

PRODUCT SAFETY & DISCLAIMER

READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE

PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY

•

This installation guide is provided as a GENERAL installation guide, some vehicles vary and

may require additional steps. We do not accept responsibility for third party labor charges

or modifications. Exercise due-diligence when installing this product.

•

We do not accept any responsibility for vehicle damage or personal injury resulting from

the installation of this product.

Careless installation and operation can result in equipment damage

•

Requirement

OEM CD auto changer

Introduction:

Just because you drive an older car does not mean you have to settle for old

technology. In 2012 Apple released a new generation of products and with them

a new lightning plug, and if you have an older iPod 30-pin adapter it will also

need updating. The iL-JAG98 updates your car to play and charge the newest

Apple products including the iPhone 12

the dashboard components. Installing this adapter requires sacrificing the CD

changer, but with the storage capacity of these new devices sacrificing the CD

changer should be an easy decision. See Frequently Asked question section at

the end of this guide for more details.

Installation

(to cd changer plug in trunk/hatch)

Warning: For the IL-JAG98 to work, vehicle must have a working CD Changer.

CD changer remains connected but will no longer play.

without sacrificing the look and feel of

Remove carpet trim piece surrounding audio rack (See Fig. 1). If rack

does not have navigation, use vacant space to access the CD changer

connecting plug, however if vehicle does have navigation, lower rack by

removing (4) 8mm nuts to access wiring.

Fig. 1

Locate short thick black pigtail cable on CD Auto changer. (See Fig. 2)

Fig. 2

Remove cable from holding tab (See Fig. 2), and disconnect by pulling

apart

(do not twist)