Discount Car Stereo IL-JAG98 빠른 시작 설치 매뉴얼 - 페이지 2

{카테고리_이름} Discount Car Stereo IL-JAG98에 대한 빠른 시작 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Discount Car Stereo IL-JAG98 6 페이지. Apple lightning for 1997-06 xk (x100) and 1998-03 xj (x308) with cd changer

PRODUCT SAFETY & DISCLAIMER
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING, FAILURE TO DO SO MAY CAUSE
PERSONAL INJURY OR DAMAGE TO PRODUCT AND/OR PROPERTY
This installation guide is provided as a GENERAL installation guide, some vehicles vary and
may require additional steps. We do not accept responsibility for third party labor charges
or modifications. Exercise due-diligence when installing this product.
We do not accept any responsibility for vehicle damage or personal injury resulting from
the installation of this product.
Careless installation and operation can result in equipment damage
Requirement
OEM CD auto changer
Introduction:
Just because you drive an older car does not mean you have to settle for old
technology. In 2012 Apple released a new generation of products and with them
a new lightning plug, and if you have an older iPod 30-pin adapter it will also
need updating. The iL-JAG98 updates your car to play and charge the newest
Apple products including the iPhone 12
the dashboard components. Installing this adapter requires sacrificing the CD
changer, but with the storage capacity of these new devices sacrificing the CD
changer should be an easy decision. See Frequently Asked question section at
the end of this guide for more details.

Installation

(to cd changer plug in trunk/hatch)
Warning: For the IL-JAG98 to work, vehicle must have a working CD Changer.
CD changer remains connected but will no longer play.
.
+
without sacrificing the look and feel of
Remove carpet trim piece surrounding audio rack (See Fig. 1). If rack
1.
does not have navigation, use vacant space to access the CD changer
connecting plug, however if vehicle does have navigation, lower rack by
removing (4) 8mm nuts to access wiring.
Fig. 1
Locate short thick black pigtail cable on CD Auto changer. (See Fig. 2)
2.
Fig. 2
Remove cable from holding tab (See Fig. 2), and disconnect by pulling
3.
apart
(do not twist)