3D AEROWORKS Pilatus PC-21 Panduan Perakitan dan Panduan Pengguna - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Perakitan dan Panduan Pengguna untuk Mainan 3D AEROWORKS Pilatus PC-21. 3D AEROWORKS Pilatus PC-21 19 halaman.
Halaman Cetak
6
From part "fuse 3" remove the inner section of the lead tunnel with a knife or heated metal
rod to allow the servo lead for the aileron to pass through. (refer image)
7
Test fit the hinges in the hinge slots for each control surface and its parent part, this will make
gluing the control surface easier when the time comes. NOTE- Do not force the hinge if it is
too tight. Loosen the slot by gently inserting a stanley knife.
Using the LW-PLA as a hinge:
From the off-cuts from the fuselage false floor, cut small sections of 15mm x 7mm with the
7mm side being against the grain of the layers. Test fit the pieces into the hinge slots of the
control surface and stabiliser or wing.