3D Factories EASY 3D MAKER Panduan Pengguna - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Printer 3D 3D Factories EASY 3D MAKER. 3D Factories EASY 3D MAKER 14 halaman.

TURN OFF THE MACHINE CALIBRATION PROCEDURE IS PERFORMED IN PRINTER disconnected from electricity!

First put the paper on the print bed. Set screws so that the paper is just touching the nozzle. ATTENTION -

PAPER must move a little freely! Do this for 3 position and be used to check again. Crossing the nozzle into the

appropriate positions perform manually.

8.4 KONTROLA TISKOVÉ PLOCHY

Check the flatness of the print area and visually using a ruler or other flat surface.

If the print surface deflection, make sure that no point no higher than the lowest set point of nozzle. If

necessary, readjust the height of the nozzle or replace the print area.

VERSION: 1.9.2012

- 8 -